J1 – Power Adapter port. Provides power to units not being powered by TNET. The DC-10 jack connects to a DV-1250/06 12VDC 500 ma power adapter.
J2 – Serial Communications port (RJ-45 jack). Connects to TLD2 and TIM1B TNET devices (RS-422). Connects to the PC during setup (RS-232 using TMA3 cable adapter).
J3 – Barcode port(s). Connects to a wand emulating barcode reader. Two barcode ports interface via a six position square post header. The standard port #1 uses pins 1-3. The optional port #2 uses pins 4-6.
Port #1
|
Pin# |
Description |
1 |
5 VDC Power |
2 |
Data input (0-5V pulses) |
3 |
Signal Ground |
Port #2
|
Pin# |
Description |
4 |
5 VDC Power |
5 |
Data input (0-5V pulses) |
6 |
Signal Ground |
J4 – Magnetic Stripe Card Reader ports. Track 1 and track 2 card readers connected to an eight position square post header.
Pin #
|
Description
|
Pin #
|
Description
|
1 |
Track #2 data input |
5 |
5 VDC power |
2 |
Card Enable |
6 |
Signal Ground |
3 |
Track #2 Clock |
7 |
Track #1 Clock |
4 |
Not connected |
8 |
Track #1 data input |
Two Relay ports interface via two four position square post headers.
J5- Relay #1 port
Pin # |
Description
|
1 |
12 VDC |
2 |
Relay terminal |
3 |
Relay terminal |
4 |
Ground |
J5- Relay #2 port
Pin# |
Description |
1 |
12 VDC power |
2 |
Relay terminal |
3 |
Relay terminal |
4 |
Ground |
The Setup and Reset buttons are recessed momentary contact switches.
S3 – Setup Button
S4 – Reset Button